Roll Slitting
Longitude Cut Line
In this lines, Steel coil is cut to a certain width in other to a lower one (ribbons or straps). The width of this coils is determined by the position of the blades that will perform the cut, being uniform throughout the whole coil.
Characteristics for Cutting:
- Galvanized, aluminized, pre-painted.
- MG-Zn-Al and Galvanneal covering
- 0.50 to 3.00 mm thickness
- Coil Width: Maximum of 1600 mm. and minimum of 100 mm.
- Receiving Chuck with maximum capability of 13 tons
- Maximum thickness cuts from 0.5 to 1.5 mm: up to 20
- Maximum thickness cuts from 1.6 to 3.00 mm: up to 8
- Cut velocity: 40-120 meters per minute.
BLANKS
Transversal Cut Lines
This cutting line has coils or steel rolls that are transformed into flat rectangular blanks or plates. In order to achieve this, coils are leveled, cut to the required length size, and finally stacked in packages that are easily manipulable and easily transported.
Characteristics for Cutting:
- Galvanized, aluminized, pre-painted.
- MG-Zn-Al and Galvanneal covering.
- 0.50 to 2.00 mm thickness.
- Coil Width: 100mm.-1250 mm.
- Receiving Chuck with maximum capability of 10 tons
- The Blank cut can have the desired length adjusted to your every need.
Personalized Service
For more information about our services
Contact us and we will offer the best conditions